2-WAY Powered Abs Molded Speakers

by Gemini

Product Details

• Product Dimensions: 20 x 14.5 x 25.5 inches ; 46 pounds
• Shipping Weight: 46 pounds
• Shipping: This item is also available for shipping to select countries outside the U.S.
• ASIN: B0002D0QEK
• Item model number: GX-350
• Average Customer Review: 1.0 out of 5 stars  See all reviews (1 customer review)
• Amazon Best Sellers Rank: #315,527 in Electronics (See Top 100 in Electronics)
• Date first available at Amazon.com: September 4, 2005

Product Description

Compression driven woofers and titanium diaphragm tweeters

High-temperature voice coils and aluminum diecast frame

XLR, 1/4" mic and line inputs with built-in mixer

XLR and 1/4" outputs for expansion

Master, treble and bass controls

Frequency response: 30Hz-20kHz

Durable black ABS molded shell with full metal grill and floor brackets

3 year warranty

Customer Reviews

Most Helpful Customer Reviews

4 of 4 people found the following review helpful:

1.0 out of 5 stars Good Speakers, Bad Internal Amplifier, April 14, 2005

By 

Isaac Creek "DJ YITIC" (Carbondale Il) - See all my reviews
(REAL NAME)   

This review is from: 2-WAY Powered Abs Molded Speakers (Personal Computers)

I'll start this out by saying I bought a pair of these, Hooked them up, turned them on and the fuses blew on them after only 5 minutes of medium volume play. I replaced the fuses and they blew immediately. I took the amps out and had a look at the amp's design and was very shocked at the inconsistent and poor build. The MOSFETS, aren't even attached to the heat sink. I've never seen an amp that didn't mount the MOSFETs directly to the heat sink. This defeats the entire purpose of the heat sink. The low-pass crossover in one unit had a 15 guage inductor coil, and the other one had an 18 guage inductor coil. One of the resistors was shorted out against another due to improper installing. The location of the frequency cancellation magnet, which the power supply runs through in order to eliminate hum, is only half an inch away from the low pass inductor, which can change the inductance of the circuit causing a different cross-over point than intended. I highly recommend that you don't buy either one of the powered units from Gemini.