Customer Reviews

2x4basics Dekmate Deck Bench Bracket, 1 single unit per pack, Sand

5 star:		(10)
4 star:		(3)
3 star:		(1)
2 star:		(1)
1 star:		(2)

 

 

I was a bit apprehensive about buying these brackets and thought that the method of anchoring them to the deck would result in a bench that would flex when I pushed back on it. I was wrong and the bench is much sturdier than I thought it would be.

I did end up putting two more screws in per bracket on the bottom near the front.

Overall these created a good looking, easy to install bench. I highly recommend them. They are cheaper than buying redwood to build your own bench brackets.

I had about an 8' straight run to put a bench in, so used four brackets. Is was fairly quick (about 2-2.5 hours, I have a power miter saw), and instructions were clear. Once installed, there was too much "wobble" in the bench - front-to-back, not side-to-side. Luckily, I had posts on the end I could brace it to, so the end result is fine, if you don't have something to brace the ends to, I'd think twice. Lastly, the bench itself is not that comfortable (I find the seat too shallow). Also, the hardware is not the highest quality, and I anticipate it will rust rather quickly (I used stainless steel deck screws to fasten the back and lower front rails). Lastly, pay extra close attention to the washers you use - very similar OD, with a different ID made me redo about 5 screws (my fault, I know). I am and advanced DIYer (I built the 450 sqft three level deck the bench was for).

This is a fantastic product.
They save you time and the fact that the brackets do not take up hardly any deck space is great.
Highly recommended.

The Deck Bench Brackets were sand color with black screws and made the bench installation as easy as it could be. I used 5/4" by 6" decking boards for the back, better result than 2 X 4s. Brackets made for a strong bench result.

I received the brackets within the time period alloted from Amazon.com
However I recently noticed that one of the packages only contained one bracket rather than the two that should of been in it.

Very disappointing.

The Brackets that I've used so far seem to work pretty well. The only flaw that I have is that the hardware that comes with the brackets is of very poor quality. I had to go out to the hardware store and purchase about $30 worth of new lag screws and deck screws. (For 12 total brackets).

I run about 13' of bench covering one side of my deck.

I used 2x6 wood for bottom pieces (seat and lower rail) and 5/4 x 6 for back rest to maximize seating depth. The seating area rests on 5/4 x 6 "extenders" that I screwed on top of bracket, they extend seating area's depth. The bench seating depth, as constructed per instructions, is on the shallow side.

I spaced the brackets a bit further than recommended. I also attached both sides of bench railing to posts on the deck and back rests are enclosed with side pieces that also attach to said posts. I followed the enclosed instructions here that show correct angles to properly integrate the bench with railing/posts.

I tested the bench before attaching to posts and it wasn't too bad. It wasn't rock stable but more than enough to trust it.

All in all, the bench is very very solid and the brackets saved me some wood/thinking about how to construct them without making major mistakes.

Great product, added an 8 foot bench to my deck without giving up much deck space. I used 2x6 deck board for a great look.

this really opens up a smaller deck as it only takes a few inches of the surface. nothing but compliments for an hours work (6 brackets). very well done, some screws were a little tough to get in, but overall an easy install. the sportsmans guide shipped very fast with no problems.

VERY happy with this purchase.

I bought these because I have a small / narrow deck (8x16) and I wanted to save as much room as possible, yet still have seating for several people and a BBQ. I was concerned about how plastic frames would look, and if they would be strong enough for what I needed. I did not build according to their direct plan, as I used 1x4's and 1x6's for a more creative look and design. I stained the wood to almost an identical color as the plastic frames so the framework would not glare out and be a focal point.
The end result is a "L" shaped seating arrangement 10 feet long by 5 feet on the end. Plenty strong as I used a couple extra supports over their recommendation for saftey. I also screwed them down in a couple extra spots. The seating looks great, takes up very little space, and saved me a bunch of time. Anytone could build this.
Cushions on the bottom are recommended if sitting for a long period. The seat is not real deep, and solid wood is just that, solid.

These brackets would probably been a really great thing...EXCEPT they are NOT Sand in color, but the ugliest, don't match anything, clash with everything shade of light olive drab you can imagine. If this does not convince you, buy one set to see for yourself. I, on the other hand, bought five and one-half sets to complete my project. Amazon gave me full credit for five sets, but I had to 'eat' the single I purchased (not through Amazon, but one of Amazons sublets). If you can find a color you can live with, these appear to be sturdy, easy to install brackets to finish your deck. These would be especially good for small decks where you want to save some room.