Baldor WWL3606 3 Horsepower 1 Phase 3450 RPM Replacement Motor (For Delta Right Tilt Unisaws)

by Baldor

Product Description

From the Manufacturer

When you count on your equipment, you can count on Baldor motors. Even better? These totally enclosed, fan-cooled, 230 volt single phase motors were made specially for the Delta right tilt Unisaw and they swivel on a rod for belt tensioning. Extra high breakdown torques for maximum cutting power.

Product Details

• Shipping Weight: 79.2 pounds
• Shipping: This item can only be shipped to the 48 contiguous states. We regret it cannot be shipped to APO/FPO, Hawaii, Alaska, or Puerto Rico.
• Shipping Advisory: This item must be shipped separately from other items in your order. Additional shipping charges will not apply.
• ASIN: B0000223WG
• California residents: Click here for Proposition 65 warning.
• Item model number: WWL3606
• Average Customer Review: 5.0 out of 5 stars  See all reviews (7 customer reviews)
• Amazon Best Sellers Rank: #684,773 in Home Improvement (See Top 100 in Home Improvement)

Customer Reviews

Most Helpful Customer Reviews

10 of 10 people found the following review helpful:

5.0 out of 5 stars Will work with older unisaw, August 27, 2000

By 

David (Jacksonville FL USA) - See all my reviews

This review is from: Baldor WWL3606 3 Horsepower 1 Phase 3450 RPM Replacement Motor (For Delta Right Tilt Unisaws) (Tools & Home Improvement)

The gentleman who returned the Baldor motor could have used the motor. The older unisaw does operate at a lower RPM as stated. To make this motor work you would need to order a replacement pulley and belts from Delta. This has a few advantages, greater horespower, high quality motor at a good price, belts available from Delta. You may need to alter the opening to make the new motor move freely from 0 to 45 degrees. Sooner or later you will have to do this anyway because Delta does not have the older motors available.

9 of 9 people found the following review helpful:

5.0 out of 5 stars Replacement in older machines, March 7, 2001

By 

butter_art "butter_art" (Tucson, AZ) - See all my reviews

This review is from: Baldor WWL3606 3 Horsepower 1 Phase 3450 RPM Replacement Motor (For Delta Right Tilt Unisaws) (Tools & Home Improvement)

I replaced the motor in my 1940s vintage Unisaw with this motor and found it to be an excellent unit. As the other gentlemen observed, it is important to check the RPM of your old motor. I called Delta and ordered a new pulley and drive belts, and installed everything in an evening. Now my saw runs better than ever! One other item to note: Be sure your switch is rated to handle the 3 HP motor. If you haven't updated your old switch, it might not be up to the additional current required for the 3 HP motor. Good luck!

7 of 7 people found the following review helpful:

5.0 out of 5 stars This Is a GREAT motor, July 20, 2001

By 

A. H. Daniels (Columbus, Ohio United States) - See all my reviews
(REAL NAME)   

This review is from: Baldor WWL3606 3 Horsepower 1 Phase 3450 RPM Replacement Motor (For Delta Right Tilt Unisaws) (Tools & Home Improvement)

I bought A used unisaw at an auction for less money than this motor . However it was 3 phase. So I went shopping I found A leeson Same spec.For a little less but I couldnt send it back if it didnt fit.Also baldor has been around a long time and have made great motors.So I order this motor and installed with new arbor and bearings.This saw blows My Old Junk craftsman out the door. I set a carb planer type blade all the way up to resaw A 2 X and it went through like butter the moter didnt slow .If your going to spend money on a motor go with 3 hp or more when you need the power your going to have it . By the way the guy at the delta part store said he would buy this moter . He couldnt get it this low with his disc. You do have to cut the side of saw not hard to do.