Crystal Clear Ghost Case for Xbox

Other products by Ghost Case

Product Details

• ASIN: B0007LE94A
• Product Dimensions: 12 x 15 x 5 inches ; 2 pounds
• Media: Video Game
• Average Customer Review: 4.0 out of 5 stars See all reviews (1 customer review)
• Amazon.com Sales Rank: #16,870 in Video Games (See Bestsellers in Video Games)

Product Description

Product Description
Limited Edition XBOX Ghost Cases allow you to completely customize your Xbox console to its fullest potential. These cases are only of the highest quality and easily install in under 15 minutes. Simply remove 9 screws and remove your old boring black case to transform it into an awesome Ghost Case. 5 pieces total: the top/side cover, front cover and buttons, DVD bezel, and 2 pieces for the DVD tray. This clear Ghost Case also glows vibrantly under black light! Great for Gifts

Customer Reviews

Most Helpful Customer Reviews

2 of 2 people found the following review helpful:

4.0 out of 5 stars Good product, looks awesome, September 15, 2006

By	P. Gratz (Milwaukee) - See all my reviews (REAL NAME)

Fun:4.0 out of 5 stars 

I recently ordered and recieved this product, it was relativly easy to install, it did take about 15 minutes to a half hour, I took my time trying not to break anything important. On the bottom of your x-box, under the rubber pads theres 4 screws(which need a special hex screw driver)and also under 2 stickers theres another 2 screws, after you get those off the top just comes off. Next was the cd-drive cover, on that I used a flat screw driver and lightly pried on the bottom (theres 2 tabs that it hold on) and that popped off and just replaced with the new one. Finally came the front face place, this took abit longer. On the bottom of the face plate there's 3 tabs that hold it inplace, also to remove on either side there are plastic clips that look like the letter V, take a flat screw driver again and compress the V and pop it loose and hold it in place (loose) and move along the bottom and pop out the other clips, and just repeat the on the other side for the V clip. IMPORTANT!! Once you get the face plate loose, DONT PULL IT OFF FAST, there's a little circiut board and wiring on there for the power/eject buttons. Theres another little clip on there that holds that on, once you get that off (the circuit board) just replace on the new face plate and reassemble in the opposite order of removal.
Overall, this is a really good product, it looks really cool when you turn the power on and the L.E.D.S. light up the front of the xbox. The only issues were that it didn't come with instructions, and it came with an extra piece that I couldnt figure out were it went.