DB Link ANLFH01 0-Gauge ANL Fuse Holder

by DB Link

Product Details

• Product Dimensions: 5.2 x 8.8 x 2 inches ; 11.2 ounces
• Shipping Weight: 1 pounds (View shipping rates and policies)
• Shipping: This item is also available for shipping to select countries outside the U.S.
• ASIN: B0002NRIKA
• Item model number: ANLFH01
• Average Customer Review: 4.5 out of 5 stars  See all reviews (6 customer reviews)

Product Description

Db Link Anlfh01 0-Gauge Anl Fuse Holder

Customer Reviews

Most Helpful Customer Reviews

2 of 2 people found the following review helpful:

5.0 out of 5 stars Big, but it works, April 22, 2011

By 

S. Nguyen (Las Vegas, NV) - See all my reviews
(REAL NAME)   

Amazon Verified Purchase

This review is from: DB Link ANLFH01 0-Gauge ANL Fuse Holder (Electronics)

I've had it in there for a year with 0 gauge wire to my two amplifiers in my trunk. Has not given me any problems in the year that I have used it. It is big in size, and clamping down the wire was kind of tough (I added electrical tape for extra security), but I have never had to inspect it or fix it since installing it last year.

1 of 1 people found the following review helpful:

4.0 out of 5 stars as described, September 27, 2011

By 

neo8544 - See all my reviews

Amazon Verified Purchase

This review is from: DB Link ANLFH01 0-Gauge ANL Fuse Holder (Electronics)

excellent construction very well made protects exposed wires perfectly just a little large is all almost 3 times the size of a standard 4 awg inline fuse would definately recommend for others to buy fits my 0 awg power wire perfectly. if you need a larger inline fuse bigger than 4 awg look no further.

1 of 1 people found the following review helpful:

4.0 out of 5 stars Set screws are too small, September 22, 2011

By 

John Woods "TObject" (San Diego, CA, United States) - See all my reviews

Amazon Verified Purchase

This review is from: DB Link ANLFH01 0-Gauge ANL Fuse Holder (Electronics)

This fuse holder is great, except for one detail. The set screws diameter is too little for the size of the contact tubes. This is fine for solid cable, but creates a problem with stranded cables, where it tends to push strands to the sides, away from the compression zone.
Also, depending on the cable used, the enclosed set screws may be too short. The enclosed screws are 7/16"-long. For smaller cables you may require set screws up to 3/4"-long. The set screw thread size is 3/8"-24 (fine).