Customer Reviews

Delta 36-519 Steel Stand for 10-Inch Bench Saw

5 star:		(4)
4 star:		(1)
3 star:		(1)
2 star:		(0)
1 star:		(1)

 

 

I purchased the Delta 36-519 steel stand for my table saw
in October of 2001. When I received it, at first I thought
they sent me the wrong stand. No that was the stand alright.
Here is why you may wish to consider avoiding buying this
stand. The stand pictured above is gray and it has two bolts
for each support upper and lower. Mine had one bolt per
support. That in itself would not be a major problem but what
is the problem is that the metal they used is around the
thickness of cheap sheet metal. If you put the stand together
and pick it up it shakes like jello.
The person that wrote the reveiw that liked the stand may have
bought it when perhaps it once was the stand pictured above or
of a better quality.

The picture does not match the stand - mine is black, and has only one bolt at each anchor point. There were no instructions in the box, but it wasn't hard to figure out. You have to do the bolts up _really_ tight for it to be rigid (I used two wrenches). However, it does hold my saw quite well. I would have preferred rubber feet, as the plastic ones don't offer much friction -- when ripping a board the whole stand sometimes slides across the floor. It's also quite expensive for what it is, especially when you compare to the price of the saw itself.

I can't believe Amazon.com had this! It was the exact stand I needed for my bench saw...Very cool!

(Update to other comments...The stand I received is the exact one pictured above. Gray with enough bolts to properly secure the stand and bolt down my table saw. I have used it with my saw for over two years and it has not fallen apart and I have not needed to tighten it. Very dependable however I do agree about the feet. My stand's feet are plastic which does tend to cause it to slide when I am working with large pieces of wood. Rubber feet would have been better. If you do not get the exact stand then send it back and demand the gray one.)

It fit my saw perfectly. The feet keep falling off, so I superglued them on. When they wear out, I'll use acetone to remove them.

I am very happy with my purchase. It had directions so it was very easy to put together. It is very sturdy and the saw fit perfect.

Man, i love it!. Am to old to keep on bending over, it is just perfect.
You know what they said, that you know that you're old when you bend to tie up your shoes and while in that position,you start thinking what else can be done before you stand up again.

I found this table very easy to assemble. It is very solid and compact. It will be easy to store and transport. So far so good!!