Delta 50-355 4-Inch Dust Connector Adapter for 10-Inch Unisaw Table Saw

by Delta

Product Description

Amazon.com Product Description

Designed for right and left tilting arbor saws, the DELTA 50-355 4-inch Dust Connector Adapter for 10-inch Unisaw Table Saws attaches over the inside opening of DELTA Unisaw cabinets (under motor cover). With a 4-inch diameter outlet, this connector adapter comes with mounting screws.

From the Manufacturer

Adapt your Delta Left-Tilt Unisaw for use with a dust collector using this connector. It mounts easily over the opening under the motor cover and connects to a 4-inch dust collector hose. Includes one dust connector.

Product Details

• Product Dimensions: 19 x 8.5 x 4 inches ; 2 pounds
• Shipping Weight: 3 pounds
• Shipping: This item is also available for shipping to select countries outside the U.S.
• ASIN: B000022349
• California residents: Click here for Proposition 65 warning.
• Item model number: 50-355
• Average Customer Review: 4.0 out of 5 stars  See all reviews (5 customer reviews)
• Amazon Best Sellers Rank: #239,127 in Home Improvement (See Top 100 in Home Improvement)

Customer Reviews

Most Helpful Customer Reviews

17 of 17 people found the following review helpful:

5.0 out of 5 stars Built solid, installation a snap, February 20, 2001

By 

"mfrishcosy" (Rochester, MI United States) - See all my reviews

This review is from: Delta 50-355 4-Inch Dust Connector Adapter for 10-Inch Unisaw Table Saw (Tools & Home Improvement)

Attached directly to my left tilt unisaw with no problems at all. Assembly was very quick (a few minutes). The plate that attaches to the cabinet is very rigid and solid. The 4" OD adaptor is more typical for a home workshop than the 5" OD alternate I have seen else (the 5" version that I have seen is just flimsy sheet metal and costs about $50). I would recommend this dust collector attachment for any home workshop that has a unisaw.

11 of 11 people found the following review helpful:

4.0 out of 5 stars Works for right-tilt Unisaws, too, March 23, 2001

By A Customer

This review is from: Delta 50-355 4-Inch Dust Connector Adapter for 10-Inch Unisaw Table Saw (Tools & Home Improvement)

The editorial review of this item is a little misleading. Yes, I'm sure it works on left-tilt saws, but it fits perfectly on my right-tilt as well. The label on the box just says "dust connector for Unisaws". This is the one to get if you run home shop-type 4" dust collector lines.

7 of 7 people found the following review helpful:

3.0 out of 5 stars Not recommended with Delta mobile base, September 23, 2001

By 

Steve Lomaro (California) - See all my reviews

This review is from: Delta 50-355 4-Inch Dust Connector Adapter for 10-Inch Unisaw Table Saw (Tools & Home Improvement)

I do not recommend this dust connector in combination with Delta's mobile base. I had two issues: The dust port is too close to the swivel caster and interferes with the hose connection. The right side exit required a tight radius bend of flex hose to get to my left side duct collection pipe. I found rear exiting 50-224 (with 5" opening) to be better.