Customer Reviews

Delta 50-355 4-Inch Dust Connector Adapter for 10-Inch Unisaw Table Saw

5 star:		(1)
4 star:		(3)
3 star:		(1)
2 star:		(0)
1 star:		(0)

 

 

Attached directly to my left tilt unisaw with no problems at all. Assembly was very quick (a few minutes). The plate that attaches to the cabinet is very rigid and solid. The 4" OD adaptor is more typical for a home workshop than the 5" OD alternate I have seen else (the 5" version that I have seen is just flimsy sheet metal and costs about $50). I would recommend this dust collector attachment for any home workshop that has a unisaw.

The editorial review of this item is a little misleading. Yes, I'm sure it works on left-tilt saws, but it fits perfectly on my right-tilt as well. The label on the box just says "dust connector for Unisaws". This is the one to get if you run home shop-type 4" dust collector lines.

I do not recommend this dust connector in combination with Delta's mobile base. I had two issues: The dust port is too close to the swivel caster and interferes with the hose connection. The right side exit required a tight radius bend of flex hose to get to my left side duct collection pipe. I found rear exiting 50-224 (with 5" opening) to be better.

This works great, and with my mobile base. I would suggest a 90-degree adaptor with a 6" length of hose to make it a bit easier to hook up to the rest of the system.

Requires the removal of the lower shelf (at least so far), but I don't really use it anyway.

THIS IS THE ADAPTOR YOU WANT IF YOU HAVE A 4" DUST COLLECTOR. THE PICTURE IS MISLEADING BECAUSE THE DUST CHUTE IS NOW OFFSET TO CLEAR ANY MOBILE BASE PROBLEMS YOU MIGHT HAVE HAD. ITS A LITTLE OVER PRICED FOR A PIECE OF SHEET METAL AND A STANDARD PLASTIC DUST CHUTE ( PART # 406-12-026-0001). IT WOULD BE MORE REASONABLE FOR AROUND 20 BUCKS, BUT FOR WHAT DELTA WANTS FOR A NEW UNISAW IT SHOULD BE INCLUDED.