Dundas Jafine UD48S Space Saver Aluminum Duct

by Dundas Jafine

Product Description

Dundas Jafine UD48S Space Saver Aluminum Duct The Dundas Jafine space saver aluminum duct is ideal for use in tight fitting clothes dryer applications.   This duct allows the dryer to be placed 3 from the wall for optimum space utilization.   With a 2-piece aluminum construction this duct also extends from 28 45 in length. Dundas Jafine UD48S Space Saver Aluminum Duct Features: Two piece adjustable aluminum duct Dryer can be installed 3" from wall Straight outlet 90 º inlet with straight outlet Extends 28" to 45" Dundas Jafine UD48S Space Saver Aluminum Duct Specifications: Description: 90 ° Inlet / Straight Outlet Pack Type: Retail Package Pack Qty: 4

Product Details

• Item Weight: 2 pounds
• Shipping Weight: 2 pounds (View shipping rates and policies)
• ASIN: B001AH3K72
• Average Customer Review: 4.0 out of 5 stars  See all reviews (2 customer reviews)
• Amazon Best Sellers Rank: #5,272 in Home Improvement (See Top 100 in Home Improvement)
  • #4 in Home Improvement > Appliances > Large Appliance Accessories > Dryer Parts & Accessories > Vents
  • #11 in Home Improvement > Building Supplies > Building Materials > Roofing > Vents

Customer Reviews

Most Helpful Customer Reviews

2 of 2 people found the following review helpful:

4.0 out of 5 stars UD48S, August 27, 2011

By 

NY TriState Buyer - See all my reviews

Amazon Verified Purchase

This review is from: Dundas Jafine UD48S Space Saver Aluminum Duct (Misc.)

Good value. The quality could be a notch or two higher. After adjusting to desired height it's a good idea to seal it with high temperature service HVAC tape.

1 of 1 people found the following review helpful:

4.0 out of 5 stars Does what it does well, October 15, 2011

By 

usaf_drew (Middle GA) - See all my reviews

This review is from: Dundas Jafine UD48S Space Saver Aluminum Duct (Misc.)

This basically does what it's supposed to - saves space and allows you to move the dryer close (3-5") to the wall. However, be sure to use plenty of HVAC tape on all the seams as they are just tack welded and crimped together. I even went sofar as to use some tape inside the unit where the collar mates with the periscope section because it's more of a slip on connection. Once at the correct height and all taped up, airflow will be quite good through it. One thing of note is the collar that attaches to your dryer is a bit short. Wasn't an issue for me, but if your dryer's exhaust is not protruding or flush with the rear, you will have to get a coupler which will defeat the purpose of this. I also used a worm drive clamp on this for good measure. For those worried about how this design will affect the overall length of their dryer exhaust run, it worked just fine for me in a 35' overall run w/ one 90. I would have given this 5 stars if it were not for the prep time it took with HVAC tape to get this installed.