Generic high quality aftermarket Roller Brush, or Beater Bar designed to fit all Dyson DC24 The Ball Upright Models. Fits Dyson Part 917390-02.
This is a high quality replacement roller brush, or beater bar assembly designed to fit the Dyson Ball DC24 Bagless Upright Vacuums, or Dyson Part Number 917390-02.
The Dyson DC24 is equipped with an automatic belt shutoff system, which will stop the brush from spinning if something get vacuumed up that prevents the brushes from spinning. If your beater bar stop spinning, you should first simply press the reset switch located on the left end cap of the brush bar housing, and turn the vacuum on.
The OEM Dyson brush however is composed of mostly plastic, and even with the shut off system, many times the damage to the brush bar has already happened before the safety switch engages, and at this point a new replacement part should be installed
This high quality replacement brush dowel includes all the components of the bar, fully assembled and ready to install. To remove your old brush roller, simply unscrew the plastic cap on the right side of the bar (if standing in front of the vacuum) to the unlock position, and rotate the baring cap towards you to remove it from the agitator housing.
Simply slide the old brush out, and slide the new on in, reattach the bearing cap, and fasten the screw back to the locked position.
<h2>Works With All Dyson DC24 Ball Uprights</h2>
Works with all DC-24 Models, including:
<li>The DC24 Multi-Floor Ball</li>
<li>Dyson DC24 Animal</li>
<li>Dyson DC24 Blueprint Limited Edition</li>
<li>Dyson DC24 Multifloor Red</li>
Fits OEM Dyson Part Number 917390-02.