General Tools 807SX 1/4-Inch Straight and No. 2 Crosspoint Ratchet Offset Screwdriver

by General Tools Mfg Co In

Product Description

From the Manufacturer

The ratchet offset screwdrivers are for hard-to-get screws especially where leverage is required. The blades are made of machined ground and hardened tool steel. This ratchet adjusts for forward or reverse position. It includes 1/4" straight and No. 2 crosspoint blades.

Product Description

General Tools 807SX RATCHET OFFSET SCREWDRIVERS General Tools 807SX RATCHET OFFSET SCREWDRIVERS Features: For reaching hard-to-get-at screws, especially where leverage is required Blades are made of machined ground and hardened tool steel Ratchet adjusts for forward or reverse position. Screwdriver ratchet Offset head for odd angle access Ratchet handle is reversible on-the-fly Provides greater amount of leverage than regular screwdriver Hardened tool steel blades General Tools 807SX RATCHET OFFSET SCREWDRIVERS Specifications: TIPS: 1/4" straight and No. 2 crosspoint blades OVERALL LENGTH: 4" (102mm) LENGTH OF BLADE: 1" (25mm)

Product Details

• Product Dimensions: 6.8 x 3.2 x 2.1 inches ; 7.8 ounces
• Shipping Weight: 1.1 ounces (View shipping rates and policies)
• Shipping: This item is also available for shipping to select countries outside the U.S.
• ASIN: B00004T7U0
• California residents: Click here for Proposition 65 warning.
• Item model number: 807SX
• Average Customer Review: 1.0 out of 5 stars  See all reviews (1 customer review)
• Amazon Best Sellers Rank: #41,640 in Home Improvement (See Top 100 in Home Improvement)

Customer Reviews

Most Helpful Customer Reviews

1 of 1 people found the following review helpful:

1.0 out of 5 stars Poor quality and performance, January 9, 2011

By 

wkgs42a (NY) - See all my reviews

This review is from: General Tools 807SX 1/4-Inch Straight and No. 2 Crosspoint Ratchet Offset Screwdriver (Tools & Home Improvement)

I bought this ratchet screw driver to replace a similar one that I had lost. I thought this looked like a direct replacement, but its quality was very poor.

The two flat pieces that make up the handle are not tightly fastened together. The combination Phillips and slot screw bit is not removeable or reversible, as had been in my older one--the Phillips end is longer and the regular slot end so short it is almost useless.

In performance, the ratchet switch was hard to set into either position, forward or reverse; during use, it keept slipping to the other setting; and it is positioned right where your thumb naturally falls during use so no matter where you set it, it is constantly being disengaged or reversed.

Don't waste your money on this one. I threw it away.

A much better and cheaper choice with a variety of bits is
http://www.amazon.com/gp/product/B000XYOUS6/ref=oss_product