Grizzly G0540 Single Spindle Horizontal Boring Machine

by Grizzly

Product Description

How many times have you wished for a simple horizontal boring machine to drill accurate holes into the edges of flat lumber for doweling, hardware alignment or basic mortising? Well, your wish has been answered with this Single Spindle Horizontal Boring Machine. 5/8" drill bit capacity. Direct drive power transfer. Approximate shipping weight of 201 lbs. ? Motor: 3/4 HP, 110V, 12 Amp, single-phase, TEFC, 3450 RPM ? Table size: 14-1/4" W x 8-1/4" D ? Table travel, side to side: 6" ? Table travel, front to back: 4-1/8" ? Table travel, vertical: 2-1/8"

Product Details

• ASIN: B00012YJT0
• California residents: Click here for Proposition 65 warning.
• Average Customer Review: 5.0 out of 5 stars  See all reviews (1 customer review)

Customer Reviews

Most Helpful Customer Reviews

2 of 2 people found the following review helpful:

5.0 out of 5 stars I think it's great, August 16, 2010

By 

just bob "bobcz" - See all my reviews

This review is from: Grizzly G0540 Single Spindle Horizontal Boring Machine (Misc.)

I received the boring machine via UPS freight ($71). I unloaded it into the front end loader of my tractor and took it into the pole barn. I easily opened the crate and inventoried the contents. There were extra bolts and nuts. There were no lock washers so I drove to town and bought some. Assembly directions were easy to read and follow. The boring machine went together smoothly and there were no complications. Cleanup was simple, quick, and easy. The directions emphasized I would need help; however, even though I am older and have several health issues, I easily put it together without any assistance.

I set it on a mobile base that was salvaged from an older table saw and wheeled it into the workshop.

I had previously purchased two (2) 2 flute, extra length, 1/4" mill ends via EBay.

I had never used a boring machine before so it took me about 30 minutes to figure out how to adjust the machine and do a set-up for 3/4" stock. After the set-up was completed I bored perfect mortises for a pair of rails and stiles for floating tenons.

I understand that this is not a router and it is not designed to "horse" through stock. To make the mortises I just took my time and nibbled away at the wood. It took me about 15 seconds to make each mortise (7/8" deep).

I had read other reviews on the Internet and the most frequent criticism of this machine was that it was not powerful enough for their usage. If you are a woodworker this is the perfect machine at a great price.