Lamello 156100 K-20 Clamping Plates Box of 250

by Lamello

Product Description

From the Manufacturer

Plate K20 (plastic) 60 x 24 x 4.5mm Is used in combination with wooden Lamello Plates. Serves as clamp until glue sets in wooden plate slots. Uses: assembly aid whee clamping the work is difficult: screens, large workpieces etc.

Product Details

• Product Dimensions: 9 x 7 x 3 inches
• Shipping Weight: 1.8 pounds (View shipping rates and policies)
• Shipping: This item is also available for shipping to select countries outside the U.S.
• ASIN: B0006N2OPA
• Item model number: 156100
• Average Customer Review: 5.0 out of 5 stars  See all reviews (1 customer review)
• Amazon Best Sellers Rank: #38,721 in Home Improvement (See Top 100 in Home Improvement)
  • #23 in Home Improvement > Power & Hand Tools > Power Tool Accessories > Plate Joiner Accessories

Customer Reviews

Most Helpful Customer Reviews

5 of 5 people found the following review helpful:

5.0 out of 5 stars The Biscut With Teeth, December 5, 2009

By 

S. banen "Mr. B" (The land of 5 "C's") - See all my reviews
(REAL NAME)   

Amazon Verified Purchase

This review is from: Lamello 156100 K-20 Clamping Plates Box of 250 (Tools & Home Improvement)

The biscuit joiner has been a part of my tool arsenal for over twenty years. The K-20 biscuit is made of plastic and has teeth or barbs molded into it. It is actually a bit wider than the standard wood biscuit and so it needs to be tapped into the slot with a mallet. This gives them tremendous holding power. On a recent project, I built a 16' x 8' cherry book case that was installed wall to wall and scribed in all around (tight to the wall and ceiling and matching all irregularities in the drywall). This was done by first installing the cabinets without the outer portions of the face frame attached. Then I shaped the side mullions and top rail to match the drywall and attached them to the front edge of the book case with the K-20 joiners. There was no way to clamp these parts in place, and I do not believe in nailing through the face of my projects........No worries; the K-20 will hold those parts tight forever and there is no visible gap between the face frame and cabinet carcass. The entire piece is tight to the wall and no scribe mold or crown mold was required. Try 'em, you'll like 'em.