I tried to use this to pull the gears off the cam for a timing job on a 2000 audi. I did grease it up before use. The screw jammed up inside instantly almost like it cross threaded before I got it tight. So I removed it and got the screw loose and it seemed to be ok, so I tried to use it again and the thing just collapsed. It may have been a bit undersized for the job, however I don't think that it required anywhere near the 2 tons it was rated for to remove the gear. The only reason I tried this puller is the 6 ton puller would not fit the gear.
Was this review helpful to you?