Superior Dyneema/fiberglass PVC dotted slabbers glove with 6-inches cuff. These highly specialized gloves were designed with the pulp and paper industry in mind. Workers there need a high level of cut protection for both hands and wrists, as well as good Dexterity and solid grip in just the right places. To that end, we have created a glove with a six inches knit wrist, an impressive cut level of CE 5 and PVC dots on the palm side of the thumb, index and middle fingers, as well as half the palm. By combining a high tech fiber like Dyneema with fiberglass, we have achieved far more than just the sum of the parts. Fiberglass on its own is brittle and breaks down under direct force. However, when combined with Dyneema, brittleness is no longer an issue, as the fiberglass is now strengthened and supported by the surrounding material. PVC dots on the palm side of just two fingers, thumb and half the palm gives you the best of both worlds: you can hang onto tools while working, but grip is not in areas where you do not need it or worse yet, where it could cause an accident. Combined with the slickness of the Dyneema knit surface, safety is increased because the baby finger side of your hand will not drag along paper rolls or other surfaces. Gloves feature built-in ergonomic shaping to enhance the all day comfort of the Dyneema knit and while they are specific to the pulp and paper industry, these gloves are also great for those working with glass, metal and other extreme cut hazards. CFIA approved for food handling. Baby finger side of glove is slick and smooth to eliminate drag along paper rolls and other surfaces, while PVC dots on three fingers and thumb side of palm provide solid grip for hanging onto tools while working. High level of cut protection for extreme cut hazard situations: CE Cut Level 5/EN 388: 2004 - 4542. Applications include pulp and paper mills, sheet metal, metal stamping and fabrication, glass handling, sharp steel.