|
|||||||||||||||||||||||||||||||||||
|
8 Reviews
|
Average Customer Review
Share your thoughts with other customers
Create your own review
|
|
Most Helpful First | Newest First
|
|
3 of 3 people found the following review helpful:
5.0 out of 5 stars
dont be cheap-buy this to install your car starter,
By
This review is from: "T" Harness for Ford Applications (Misc.)
this part allows you to install the car starter without hacking into your ignition wire harness.saves a lot of time and insures that you have a good connection. a lot of current goes through these wires and a bad homemade connection will cause a no start or worse(electrical short or meltdown or fire!).if you change cars you can reuse the harness in your new car.(as long as it is a ford).
2 of 2 people found the following review helpful:
3.0 out of 5 stars
Not Sure It Was Worth Bothering With,
By Reverend Dan "Faith is hope, not reality" (Outer Banks, NC) - See all my reviews
This review is from: "T" Harness for Ford Applications (Misc.)
It saves a little work, but not much. I would say, for the average Joe, this harness represents maybe 10 to 20 percent of the overall job, no more. Worth it? You decide.
2 of 2 people found the following review helpful:
4.0 out of 5 stars
Glad to have it,
By Charlie "busboy4" (Toledo, Oh United States) - See all my reviews
This review is from: "T" Harness for Ford Applications (Misc.)
As mentioned this device was not essential. However, as it eliminated identifying and tapping 6 major wires I enjoyed having it. Finding and tapping the parking light and lock/trunk wires was a big enough job. This harness is a bit difficult to install as both it, and the factory harness are fairly rigid due to the heavier gauge wiring on some of the lines. However it makes the installation clean and straight forward. For only $20 delivered I would highly recommend its use.
2 of 2 people found the following review helpful:
1.0 out of 5 stars
Not Worth It,
By
This review is from: "T" Harness for Ford Applications (Misc.)
There are only several taps made into the wires. If you don't mind making those taps, then don't order this. Also, it is really hard to stuff all of the wires back under the dash. Disconnect the existing plug (must undo 1 bolt) and then tap into the wires. It's a lot less bulky!
1 of 1 people found the following review helpful:
2.0 out of 5 stars
T-Harness is over-rated,
By
This review is from: "T" Harness for Ford Applications (Misc.)
There are limited connections made with the harness, you have many others to do in addition. On top of that, the harness is large so in a car with limited room behind the dash you have problems getting it all stuffed back in there.
3.0 out of 5 stars
Not quite what I expected, but still worked,
By
This review is from: "T" Harness for Ford Applications (Misc.)
I am only giving this item 3 stars because the description is somewhat misleading. It does save some time during the installation of a remote starter, but it does not cut installation time in half. This item is also made outside of the U.S. unlike most other Bulldog products made in the U.S.A. The item ends up being very bulky with an extra amount of wiring to hide under the dash. I might consider using an item like this again, but it would strictly depend on the vehicle. I wouldn't recommend it just because its available.
5.0 out of 5 stars
T harness,
This review is from: "T" Harness for Ford Applications (Misc.)
I believe this part made it alot easier for my husband to hook,up the alarm
1.0 out of 5 stars
if you want to save time get t harness,
By
Amazon Verified Purchase(What's this?)
This review is from: "T" Harness for Ford Applications (Misc.)
if you want to save time always use a t harness made the job so much easyer
|
|
Most Helpful First | Newest First
|
|
"T" Harness for Ford Applications by JBS Technologies
Out of stock
| ||