Cole Jaw Set

by Teknatool

Product Description

These versatile jaws of sturdy 3/8" thick cast aluminum with a 10" diameter have the same basic configuration as the smaller 25mm and 50mm units and can expand into a 95-117mm (3-3/4"-4-5/8") dovetailed recess, or clamp the outside of a turned dovetailed foot 84-104mm (3-5/16"-4-1/8") in diameter. Space the 8 rubber stoppers in any of 8 diameter positions on the face of the collet plates to finish the bottom of a bowl up to 10" in diameter. For larger bowls the stoppers may grip from the inside as the chuck expands outward. Any of your own custom made wooden plates may be applied. Manufacturer recommends not to exceed 600 RPM with Cole Jaw Set.

Product Details

• Item Weight: 2.8 pounds
• Shipping Weight: 3 pounds (View shipping rates and policies)
• ASIN: B000928TI4
• California residents: Click here for Proposition 65 warning.
• Item model number: JSCOLE
• Average Customer Review: 4.0 out of 5 stars  See all reviews (3 customer reviews)
• Amazon Best Sellers Rank: #87,998 in Home Improvement (See Top 100 in Home Improvement)
  • #56 in Home Improvement > Power & Hand Tools > Power Tool Accessories > Lathe Accessories > Chucks

Customer Reviews

Most Helpful Customer Reviews

6 of 6 people found the following review helpful:

5.0 out of 5 stars If you own a Teknatool chuck, buy this, November 13, 2007

By 

Dusty (wetter washington) - See all my reviews

This review is from: Cole Jaw Set (Misc.)

This may be the best thing, other then a vacuum chuck, for reverse chucking a bowl.
Why do you need to reverse a bowl... To take the mount (be it a tenon or face plate) off and improve the looks of the base

The major downside to this jaw set, is if you use it on ANY chuck, other then a Titan. The reason is the SN, SN2, G3 and Midi all have a smaller range of adjustment, then the step size between the mount point for the rubber bumpers. While the Titan has enough adjustment so this is not an issue.
If you have troubles adjusting the cole-jaws to your bowl, take the rubber bumpers off, and sand one side of each bumper, this will give you enough adjustment to allow you to reverse chuck any bowl.

Oh and one more thing... If your jaw set comes with the shown BLACK bumpers, order a spares set from your Teknatool dealer, since the spare set is WHITE. The black bumpers can (and often do) leave little marks on your bowl (not good, with say a holly bowl)

2 of 3 people found the following review helpful:

5.0 out of 5 stars Nova Cole Jaw set, March 24, 2008

By 

Big Joe "N da shop" (Sespe , CA USA) - See all my reviews

This review is from: Cole Jaw Set (Misc.)

Outstanding product, easy to use and built very well. Oh so much easier to turn the bottom of boxes and bowls. At some point I will fork out the bucks and buy a second nova chuck so I can leave it on the and not have to switch jaws (although it just takes about 10 minutes to switch the jaws).

0 of 1 people found the following review helpful:

2.0 out of 5 stars Not strong enough, December 13, 2011

By 

Joe User (Hartford, CT) - See all my reviews

Amazon Verified Purchase

This review is from: Cole Jaw Set (Misc.)

Every bowl I try to make on this ends up smashing on the floor, no matter how much I tighten it, and how careful I turn.