Wiremold C50 White Cordmate II 5-Foot Wire Channel,

by Wiremold

Product Description

Amazon.com Product Description

The Wiremold White Cordmate II 5-foot wire channel is ideal for holding networking cables and audio and video wiring. The self-adhesive backing is easily attached onto baseboards or walls, and the white channel can be painted or stained to match a room's color. The channel snaps open and shut, and it includes a hinged raceway for added convenience.

Product Details

• Product Dimensions: 60 x 1 x 0.5 inches ; 0.8 ounces
• Shipping Weight: 1.6 ounces (View shipping rates and policies)
• Shipping: Currently, item can be shipped only within the U.S. and to APO/FPO addresses. For APO/FPO shipments, please check with the manufacturer regarding warranty and support issues.
• Shipping Advisory: This item must be shipped separately from other items in your order. Additional shipping charges will not apply.
• ASIN: B000BW0YH6
• Item model number: C50
• Average Customer Review: 3.8 out of 5 stars  See all reviews (22 customer reviews)
• Amazon Best Sellers Rank: #626 in Home Improvement (See Top 100 in Home Improvement)
  • #85 in Home Improvement > Electrical

Customer Reviews

Most Helpful Customer Reviews

16 of 17 people found the following review helpful:

5.0 out of 5 stars To the point, May 12, 2009

By 

L. Thibodeau (NY) - See all my reviews
(REAL NAME)   

This review is from: Wiremold C50 White Cordmate II 5-Foot Wire Channel, (Tools & Home Improvement)

Works *exactly* as advertised. Note that it's only 1" wide and *is* 60" long so you do get the full five feet. Good solid plastic material and seems like a quality product.

> Setup: One 52" Sony XBR LCD hanging on the wall. Wall mount has the lower base of the TV about 40" off the ground. All my compenents are installed in a media center that is about 20" high.
> I had one monster HDMI cable, one Sony XBR LCD power cord, 5 Bose speaker wires.
> Material needed - hacksaw
> I needed two runs since all these cables will not fit into one slot.
> 22" for each run and I used the other 6" for covering one front speaker wire from the side to the back of the LCD.
> Use a *sharp* hacksaw to make your cuts.
> Run 1: HDMI plus 2 speaker wires; Run 2: power cord plus 3 speaker wires.
> Insert cables into wiremold track; snap together and put up against wall - do not take off adhesive strip at this point.
> Use a level and mark where you will install it.
> Remember to extend the molding at least 1" at each end to make sure the wires are well hiden. I went 2".
> Install the two runs side by side which makes it look like one run.
> Peel off backing, line your molding to your markings and apply pressure for each run.
> Looks great.
> Total time - 10 minutes
> DONE

13 of 14 people found the following review helpful:

5.0 out of 5 stars LOVE THIS STUFF, June 22, 2008

By 

R. Parker (San Diego) - See all my reviews
(VINE VOICE)    (REAL NAME)   

This review is from: Wiremold C50 White Cordmate II 5-Foot Wire Channel, (Tools & Home Improvement)

I ran my 4 separate monster xp speaker wires along where the ceiling and the wall meet. Then I put my crown moulding over it. It help keep everything together and made it easy to put up 5.25 inch moulding over it without the wires all over the place! In one direction there are 4 wires that fit nice in the channel and in the other direction I ran the CAT5e, Coaxial Cable and Phone line to the dining area. Very easy to use and cut. I also used all the corner pieces and then the three way channel to bring the wires down into a small hole in the drywall and out behind the cabinet so I didn't have to see anything and not one dryawall repair needed. Nice stuff.

11 of 12 people found the following review helpful:

5.0 out of 5 stars works great!, September 27, 2007

By 

Art vandelay "importer/exporter" (Chesapeake beach MD) - See all my reviews

This review is from: Wiremold C50 White Cordmate II 5-Foot Wire Channel, (Tools & Home Improvement)

I used this to hide 3 speaker wires and two cables from my directv PVR. and they all fit!