Cuisinart SPB7-20TXN Blender Blade Driver Clutch

Other Cuisinart products

Product Details

• Shipping Weight: 8 ounces (View shipping rates and policies)
• ASIN: B000PJ6KI2
• Average Customer Review: 4.1 out of 5 stars  See all reviews (14 customer reviews)
• Amazon.com Sales Rank: #17,008 in Kitchen & Dining (See Bestsellers in Kitchen & Dining)

Product Description

Product Description

The Cuisinart SPB7-20TXN Blender Blade Driver Clutch fits models BFP703 BFP-703 BFP703B BFP-703B BFP703CH BFP-703CH SPB-7 SPB7 SPB-7BK SPB7BK SPB-7CH SPB7CH SPB-7BC SPB7BC CB7 CB8 CB9 BFP-703BK BFP703BK CB-9 CB9 FPB-5PC BFP703R BFP-703R CB-3 CB-4 CB-5 CB-6 CB-7 CB-8 CB-18 CBT-500 CBT-600 SPB-3 BC-56 CB-600FPPC CB-600PC FPB-5PC1

Customer Reviews

Most Helpful Customer Reviews

4 of 4 people found the following review helpful:

5.0 out of 5 stars FINALLY FOUND IT! GREAT ITEM!!! Super easy to install!, March 9, 2009

By	R. Celin (Tampa, FL) - See all my reviews (REAL NAME)

I thought I was going to have to throw out this blender since I couldn't find this part anywhere on Cuisinart's site, that is until I found it here on Amazon! This part took UNDER 5 minutes to replace.

Remove 3 screws on the bottom of the blender
Pull off cover
Use a screwdriver to keep the motor's shaft from spinning
On the other side, use a wrench, grab and unscrew the brass ring in a clockwise motion (It's reverse threaded)
Screw on new replacement blade driver (Counter-clockwise to tighten)
Put blender cover back on
Reinstall the 3 screws on the bottom of the blender
You're done!

I'm serious when I say that the whole process took me about 3 minutes.

REALLY beats having to buy a new blender.

2 of 2 people found the following review helpful:

4.0 out of 5 stars brass plate, July 15, 2008

By	Lindsay (Troy, MT) - See all my reviews

Fyi, the brass plate has reverse threads. So the rule of, righty tighty and lefty loosy, do not apply in this case. Try turning the brass threads to the right to take it off and maybe you can then use the replacement clutch. GOOD LUCK, I hope this helps.

2 of 2 people found the following review helpful:

1.0 out of 5 stars Don't get this unless you can remove the brass II, July 3, 2008

By	Anonymous (Portland, Oregon) - See all my reviews

I concur with the earlier review entitled "Don't get this unless you can remove the brass" - sadly I did not realize what this reviewer meant until I received the piece and found that on the bottom side, not shown in item image on website, that there is a redundant brass threaded hole permanently glued in. I really cannot remove the brass piece and so I cannot use this replacement part.