Delta 36-519 Steel Stand for 10-Inch Bench Saw

Other products by Delta

Product Description

From the Manufacturer
Delta 36-519 Steel Stand for 10-Inch Bench Saw

Product Details

• Product Dimensions: 26 x 4 x 3 inches ; 12.6 pounds
• Shipping Weight: 12.8 pounds
• Shipping: Currently, item can be shipped only within the U.S.
• Shipping Advisory: This item must be shipped separately from other items in your order. Additional shipping charges will not apply.
• ASIN: B000022357
• California residents: Click here for Proposition 65 warning.
• Item model number: 36-519
• Average Customer Review: 3.8 out of 5 stars See all reviews (6 customer reviews)
• Amazon.com Sales Rank: #54,688 in Home Improvement (See Bestsellers in Home Improvement)

  Popular in these categories: (What's this?)

  #19 in	Home Improvement > Power Tool Accessories > Stands > Table Saw Stands
  #58 in	Home Improvement > Power Tool Accessories > Saw Accessories > Saw Stands

Customer Reviews

Most Helpful Customer Reviews

11 of 11 people found the following review helpful:

1.0 out of 5 stars So Bad, it's almost funny, December 5, 2001

By A Customer

I purchased the Delta 36-519 steel stand for my table saw
in October of 2001. When I received it, at first I thought
they sent me the wrong stand. No that was the stand alright.
Here is why you may wish to consider avoiding buying this
stand. The stand pictured above is gray and it has two bolts
for each support upper and lower. Mine had one bolt per
support. That in itself would not be a major problem but what
is the problem is that the metal they used is around the
thickness of cheap sheet metal. If you put the stand together
and pick it up it shakes like jello.
The person that wrote the reveiw that liked the stand may have
bought it when perhaps it once was the stand pictured above or
of a better quality.

6 of 6 people found the following review helpful:

3.0 out of 5 stars adequate, but not ideal, December 12, 2001

By A Customer

The picture does not match the stand - mine is black, and has only one bolt at each anchor point. There were no instructions in the box, but it wasn't hard to figure out. You have to do the bolts up _really_ tight for it to be rigid (I used two wrenches). However, it does hold my saw quite well. I would have preferred rubber feet, as the plastic ones don't offer much friction -- when ripping a board the whole stand sometimes slides across the floor. It's also quite expensive for what it is, especially when you compare to the price of the saw itself.

3 of 3 people found the following review helpful:

5.0 out of 5 stars Delta Steel Stand, March 3, 2000

By	T. A. Ries (The Great Northwest) - See all my reviews

I can't believe Amazon.com had this! It was the exact stand I needed for my bench saw...Very cool!

(Update to other comments...The stand I received is the exact one pictured above. Gray with enough bolts to properly secure the stand and bolt down my table saw. I have used it with my saw for over two years and it has not fallen apart and I have not needed to tighten it. Very dependable however I do agree about the feet. My stand's feet are plastic which does tend to cause it to slide when I am working with large pieces of wood. Rubber feet would have been better. If you do not get the exact stand then send it back and demand the gray one.)