Bosch TS1007 Dado Insert

Other products by BOSCH (S-B Powertools)

Product Description

From the Manufacturer

For use Bosch 4000 table saw with stack dado and rabbet cutters.

Product Description

For use w/ stack dado/rabbet cutters. - Specifications: Part Number: TS1007, Used on Model No. : 4000, Sales Pack Quantity: 1.

Product Details

• Shipping Weight: 11.2 ounces (View shipping rates and policies)
• Shipping: This item is also available for shipping to select countries outside the U.S.
• Note: Gift-wrapping is not available for this item.
• ASIN: B00004R9LH
• California residents: Click here for Proposition 65 warning.
• Item model number: TS1007
• Average Customer Review: 3.5 out of 5 stars  See all reviews (19 customer reviews)
• Amazon.com Sales Rank: #824 in Home Improvement (See Bestsellers in Home Improvement)

  Popular in this category: (What's this?)

  #5 in

  Home Improvement > Power Tool Accessories > Saw Accessories > Table Saw Accessories

Customer Reviews

Most Helpful Customer Reviews

50 of 51 people found the following review helpful:

4.0 out of 5 stars Info on how to use dado Insert, August 23, 2006

By	Geo "Geo" (STL,MO) - See all my reviews

Dado insert was functional. It fit properly. To use a 13/16" dado stack with this insert on your saw you need to do this. (Per Bosch Tool customer service)

Thank you for writing Bosch Power Tools. When mounting dado blades on
the Bosch 4000 table saw, follow this procedure which was omitted from
the owners manual. This saw will handle up to a 13/16" wide dado blade.
Remove both blade washers from the arbor shaft. Install & use the Outer
washer as the Inner washer, than[sic] mount your dado blade set, than[sic]
install the lock nut. An outer washer is not needed for a dado set. This
procedure will provide proper spacing of your dado blade set. Changing
blades can be a bit tight, but if you insure the blade is elevated to it's
maximum height you shouldn't have any problem. The reason for this is
because the dust containment shroud is rather close to the blade to
contain saw dust from blowing all over the place. If you have any further
questions, please write back.

68 of 74 people found the following review helpful:

1.0 out of 5 stars Dado insert, April 9, 2002

By	Steven Fischer (North Granby, Ct USA) - See all my reviews

Disappointed with the insert. Love the saw and the stand. The dado insert only allows a 1/2" cut. A 3/4" dado setup rubs against the insert. You'd need to take the stabilizer off to have the blades be centered. It's as if no one tried it after it was developed.

32 of 37 people found the following review helpful:

1.0 out of 5 stars Don't bother, February 6, 2003

By	Colin J. Clarke (Mount Pleasant, SC USA) - See all my reviews (REAL NAME)

After struggling somewhat with fitting it and the dado blade to the drive, I decided it would be better to use it as a good template for my own homemade Insert.