Most Helpful Customer Reviews
|
|
266 of 266 people found the following review helpful:
5.0 out of 5 stars
Excellent, November 16, 2005
I've had the Polder 362-90 for about 5 years. I purchased it after seeing Alton Brown using one on the Food Channel show "Good Eats". Now, I'd be lost without it. It takes all the guesswork out of roasting chicken or turkey or a roast beef or whatever else you care to cook in your oven.
You insert the metal probe into whatever you're cooking, set the target temperature and start roasting. When your roast reaches the desired temperature, the Polder will beep to let you know. Perfectly cooked. No wiggling Mrs. Chicken's legs, no pressing on the roast, no "Gee, is it done? I'm not sure." It couldn't be easier.
It has a countdown timer (but not a clock) as well. The back of the main unit has 2 strong magnets which allow it to be attached to any metallic surface, vertical or horizontal. The LCD pivots, so no matter where you put the unit, you can tilt the LCD to make it easy to read. A slide switch on the back allows you to change between Farenheit and Centigrade.
When you wash the probe, you *must* be careful. The probe is a metal tube that contains a temperature sensor. At the point where the cable from the main unit enters this tube, it is sealed merely by crimping the tube. It isn't waterproof. So during washing, if you allow water around this area, it will find its way into the tube and kill the sensor. This is the basis, I believe, for many of the complaints regarding the probe's fragility.
I wrap my hand tightly around the top of the probe when I wash it to prevent this from happening, and I'm still using the original. I use it at least twice a month, so that means it has been used at least 100 times and washed 100 times and it works fine. As far as complaints that the sensor is inaccurate, I've got 100+ perfectly cooked chickens, turkeys and roast beefs that contradict that assertion.
If I have a complaint its that the thing has no on/off switch! Its always running and, therefore, draining the AAA battery. This is not a big deal. The first battery lasted about 3 years and the one in it now has about 2 years of use and is still going strong. When the temperature reads "LO", that is the indicator that the battery needs replacement.
The Polder 362-90 allows you to know when your roast is done instead of guessing at it. I find it essential and I recommend it. Just be careful when you wash it.
|
|
|
27 of 28 people found the following review helpful:
5.0 out of 5 stars
It Does Everything But Cook For You, October 27, 2007
I bought two timers, this Poulder and a 6 buck Taylor. The Taylor was for timing things that take under 10 minutes and I could set next to the outdoor BBQ. The Poulder was for more complex stuff like actually telling the temperature of the meat (or fish or whatever) when it's in the oven. It works. It works beautifully. My wife loves it.
BUT, this is our second one. The first lasted about four years before the tabs that allow it to sit upright on a countertop either wore out or broke. That meant that it couldn't be seen straight on unless you used the magnetic backing and "pasted" it on the range. I don't know if that will happen again. I don't know if it's a design flaw. It's plastic, so maybe four years is more than I should have expected. The timer still worked, and I suppose Poulder would have replaced it if I wanted to go to the trouble. Giving them the benefit of the doubt and the fact that it does work very well, 5 stars.
|
|
|
71 of 83 people found the following review helpful:
5.0 out of 5 stars
Old Reliable, November 25, 2004
I have used this thermometer for the better part of 3 years now, and I am sorry to say that I killed it this Thanksgiving. I had the probe in the turkey, and left the unit sitting on the stovetop. Problem was, all 4 burners were on and fried the internals.
Now I will buy a new one. I used it in the oven, for bbqing, timing, you name it, I got my moneys worth from this guy.
I must now go mourn.
|
|
|
Most Recent Customer Reviews
|
