Sunforce 7 Amp Charge Controller

Other products by Sunforce

Product Features

• Charge controller prevents overcharging of 12-volt batteries
• Intended for use with 12-volt solar panels
• Handles up to 7 amps of array current and up to 100 watts of solar power
• Charging light indicates the battery is charging, and a green light indicates a fully charged battery
• Measures 4 x 1 x 2.5 inches (WxHxD) and weighs one pound

Product Details

• Product Dimensions: 4 x 2.2 x 7 inches
• Shipping Weight: 3.2 ounces (View shipping rates and policies)
• Shipping: Currently, item can be shipped only within the U.S.
• Note: Gift-wrapping is not available for this item.
• ASIN: B0006JO0XI
• Item model number: 60012
• Average Customer Review: 4.4 out of 5 stars  See all reviews (22 customer reviews)
• Amazon.com Sales Rank: #350 in Automotive (See Bestsellers in Automotive)

  Popular in this category: (What's this?)

  #3 in

  Automotive > Tools & Equipment > Jump Starters, Battery Chargers & Portable Power > Renewable Energy > Solar Panels

Product Description

Product Description

The Sunforce 60012 7 Amp Charge Controller prevents overcharging of 12-volt batteries. It is intended for use with 12-volt solar panels, and can handle up to 7 amps of array current and up to 100 watts of solar power. The controller is easy to use with a charging light that indicates that your battery is charging, and a green light that indicates a fully charged battery. The 60012 measures 4 x 1 x 2.5 inches (WxHxD) and weighs one pound.

Customer Reviews

Most Helpful Customer Reviews

49 of 50 people found the following review helpful:

4.0 out of 5 stars Sunforce 7 amp Solar Controller , January 6, 2008

By	Jordan Xaviers "IT Mega Guy" (Jamaica, W.I.) - See all my reviews

Bad:
Really cheap quality. Included instructions don't provide enough information. Website is just as un-informative. Cheap connector wires (low current), and is not equipped with screw-on terminal junctions.

Good: Product works as advertised. Amazinlgly "regulates" the voltage to the required amount so as not to overcharge the battery. Beware though, in order to test the actual output voltage, you must apply a load on the battery end of the controller BEFORE. Failing this, the output can register volts as high as 20 volts !!! Apparently applying an actual load causes the controller to output the correct voltage range - lucky me, cause I bought 4 units ! The LEDS alternately flickers (fast for good voltage input and slow for low to no voltage on solar panel). The manual did NOT state the order of LED flashes.
(1) Fast LED flashes - good voltage/current
(2) Slow LED flashes - low/no voltage/current
(3) steady Green - fully charged
(4) steady amber - possible no load OR really low voltage/current

I recommend you go out and buy 'em. The are a really good deal and does the job at the best price ! I use them in Jamaica, to provide my appliances with power during power outages (very frequent here). Used with solar panels and DC to AC inverter, of course. Considered using a generator, but too many accidents here with generators, too noisy, too bulky, and during hurricane aftermath, fuel is a problem. Solar is freely available, so it was the BEST option all round.

Hope this helps all readers !

14 of 15 people found the following review helpful:

5.0 out of 5 stars Charger, December 5, 2007

By	Stephen Moczary "Raven Two" (New Mexico) - See all my reviews (REAL NAME)

I have this unit connect to two automotive 12V batteries with three 15W panels connect to it. So far the charger works as advertised by preventing battery drain when the sun goes down and charging while the panels are producing at least 13 volts. It is pretty much an install and forget item. Additionally I have those same two batteries tied into one of my trucks 12V power points so that the batteries charge when the vehicle is running by way of the alternator. Even with this double charging set up, the charge controller appears unphased and shows a charge light in the daytime and has on two occasions indicated a fully charged green light.

5 of 5 people found the following review helpful:

5.0 out of 5 stars Easy to use Charge Controller, October 2, 2007

By	A. Moore (Hamilton, MS) - See all my reviews (REAL NAME)

Two wires to the battery and two wires to the solar panel. It doesn't get much simplier than that. Worked flawlessly out of the box. Yellow LED indicates charging while green LED indicates the battery is charged.