|Item Weight||11.1 pounds|
|Package Dimensions||20 x 16 x 9.8 inches|
|Item model number||311082|
|Manufacturer Part Number||311082|
|OEM Part Number||311082|
Other Sellers on Amazon
+ Free Shipping
+ Free Shipping
+ Free Shipping
Anzo USA 311082 Cadillac/Chevrolet/GMC Red/Clear (Gen 3) LED Tail Light Assembly - (Sold in Pairs)
- Enter your model number to make sure this fits.
- Easy to install - directly replaces factory lenses
- Thermo-Hygrometer (temperature and humidity chamber) and Rain-Resistant tested
- SAE (Society of Automotive Engineers) and D.O.T. (Department of Transportation) compliant with FMVSS (Federal Motor Vehicle Safety Standarts) No. 108.
- Provides clean and great match for hi-tech Euro style
Customers who viewed this item also viewed
A complete kit for simple plug and play installation for custom style, design and additional safety. LED’s give you increased light output, react faster and are more durable than any conventional taillight available. AnzoUSA LED taillights are direct replacement to your outdated factory OEM taillights and produce more light per watt than do incandescent bulbs. LED’s being solid state components, are difficult to damage with external shock. Furthermore, LED’s have an extremely long lifespan. Manufacturers have calculated the ETTF (Estimated Time to Failure) for their LED’s to be between 100,000 and 1,000,000 hours. Fluorescent tubes typically are rated at about 10,000 hours and incandescent light bulbs at 1,200-2,000 hours. LED’s use less power, emit almost no heat and offer superior brightness – over 10x blighter than the incandescent bulbs.
Top customer reviews
There was a problem filtering reviews right now. Please try again later.
There are two screws that hold each tail light on. Buzz out the two screws then simply pull out the old tail lights. But before you do anything disconnect the wired connection from under the rear of the vehicle, just up from the rear bumper. After the two screws are removed and the wiring is disconnected simply give'er a good pull and they pop right out.
When I did the right side, I made the mistake of not disconnecting the wiring first. After I pulled out the old tail light I let it dangle on the bumper while I went under to disconnect the wiring. I think I might have scratched the bumper. The scratch might have been there before. But, nonetheless, disconnect the wiring first!
HOW THEY LOOK
When the brakes are suppressed, the entire rear lighting of the tail lights light up vs. just the top circle of the OEM. When you have the head lights on all lights in the rear tail lights light up and when you hit the brake it lights brighter vs. using different lights for running lights and different ones for the brake lights. The horizontal brake light at the top of the lift gate still lights up when hitting the brakes.
The contour, spacing and overall look is exceptional. I was hesitant of purchasing aftermarket lights as I have seen some that look cheesy or like the vehicle has been dumbed down. This is not the case with these lights!
I don't know how they fit and look on other vehicles, but they fit perfectly, very easy to install and they look clean, bright and stout on my 2013 Yukon Denali.
Follow-up as of June 2015 - you'd think I'd learn from prior experience. Installed a second set and after 90 days had the same problem - water leaks into the backup light section of the light fixture and creates condensation that completely fills the backup light area. The lights are either not sealed properly or don't vent properly...or both. I'm done with these.