|Item model number||ABX00004|
|Item Weight||0.32 ounces|
|Product Dimensions||3.15 x 2.17 x 0.79 inches|
|Item Dimensions LxWxH||3.15 x 2.17 x 0.79 inches|
|Is Discontinued By Manufacturer||No|
|Date First Available||August 27, 2016|
Arduino MKR1000 WiFi - ABX00004 - Loose Headers
Enhance your purchase
- Make sure this fits by entering your model number.
- MKR1000 combines the functionality of the Zero and the WiFi Shield.
- Perfect for IoT projects!
- Loose Headers (Not mounted. Soldering required). Board also available with mounted headers.
Arduino MKR1000 has been designed to offer a practical and cost effective solution for makers seeking to add Wi-Fi connectivity to their projects with minimal previous experience in networking. It is based on the Atmel ATSAMW25 SoC (System on Chip), that is part of the SmartConnect family of Atmel Wireless devices, specifically designed for IoT projects and devices. The design includes a Li-Po charging circuit that allows the Arduino/Genuino MKR1000 to run on battery power or external 5V, charging the Li-Po battery while running on external power. Switching from one source to the other is done automatically.A good 32 bit computational power similar to the Zero board, the usual rich set of I/O interfaces, low power Wi-Fi with a Cryptochip for secure communication, and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor.The USB port can be used to supply power (5V) to the board.The Arduino MKR1000 is able to run with or without the Li-Po battery connected and has limited power consumption. The MKR1000 Wifi module supports certificate SHA-256. Warning: Unlike most Arduino & Genuino boards, the MKR1000 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.
Reviewed in the United States on October 10, 2016
Reviews with images
Top reviews from the United States
There was a problem filtering reviews right now. Please try again later.
By Chief54 on October 10, 2016
I soldered the terminals and tested and it works ok!
Excelent product! Excelent service!