Safety InformationInfant car seats made 2011 or after have an expiration date of 7 years from manufactured date. STOP using this car seat and throw it away 7 years after the date of manufacture. Look for date of manufacture label on back of the car seat. Infant car seats made prior to 2011 have an expiration date 6 years from manufactured date. (General Warnings) The American Academy of Pediatricians (AAP) and National Highway Safety Administration (NHTSA) recommend that children ride rear-facing until the age of 2 or until they reach the maximum rear facing height or weight rating for their car seat. *Always remember to check your local or state laws regarding car seat usage.
IndicationsDimensions: Length: 28", Width: 18.66", Height: 15.59" Weight differs depending upon model: SnugRide Click Connect 35: Weight without base: 7.5 lbs Weight with base: 14.17 lbs SnugRide Click Connect 35 LX: Weight without base: 9.6 lbs Weight with base: 15.82 lbs Rear-Facing Only. Weight: 4-35lb Height: up to 32" Head must be more than 1" from the top of the headrest "
DirectionsMachine-washable seat cushion and canopy Metal and plastic parts may be cleaned with mild soap and cool water Buckle may be cleaned with a damp cloth Harness straps may be spot cleaned Refer to your manual (see link below) for full cleaning instructions To Unbuckle Harness: 1. Lift the lever and pull the shoulder harness straps to loosen the harness 2. Tilt the top of the buckle toward the child’s abdomen 3. Press in at the top of the red button 4. Pull tongues out of the buckle Harness Buckle Cleaning Process: Turn the restraint over and push the retainer through the harness strap slot to remove the buckle from the car seat. Place the buckle in a cup of warm water upside down and gently agitate the buckle, pressing the red button several times while it is in the water. Do not submerge the harness webbing and do not use soaps or lubricants, only rinse the harness buckle with warm water. Shake out the excess water and allow the harness buckle to air dry. Reattach the harness buckle into the same slot and re-check harness for correct installation according to the car seat manual before use.