Pro auto compound for rapid defect removal & minimal swirls

Meguiar’s M105 Mirror Glaze Ultra Cut Compound is formulated with exclusive, super-micro abrasive technology for removing below surface defects like scratches, acid rain, severe swirls and holograms, and up to 1200 grit sanding marks. Using advanced SMAT (Super Microscopic Abrasive Technology) you get an ultra-fast cut that permanently removes defects while leaving a best in class finish with minimal swirls. Meguiar’s Ultra Cut Compound can be applied by hand, dual action polisher, like Meguiar’s MT300 DA Polisher, or by Rotary Buffer. This professional auto body compound is safe for a body shop environment and is available in 8 oz, 32 oz and 1 gallon sizes. Follow with Meguiar’s M205 Mirror Glaze Ultra Finishing Polish to further refine paint and maximize depth of shine before applying a wax or sealant like Meguiar’s M21 Mirror Glaze Synthetic Sealant 2.0.

Applying Meguiar’s M105 Ultra Cut Compound

Method 1: Applying by hand

• Distribute a small amount of compound on a Meguiar’s Soft Foam Applicator Pad

• Work in a 1-2 square foot area in a circular pattern, making 4-5 overlapping passes per section to ensure that the compound has been properly applied.

• Without letting the product dry, use a fresh, clean Meguiar’s Supreme Shine Microfiber Towel to remove the residue. Flip your towel to a clean side for a final wipe.

• Reapply the compound if you didn’t remove the defects with the first application. Apply in sections like this over the vehicle.

Method 2: Applying by Meguiar’s MT300 Dual Action Polisher

• Attach Meguiar’s Red Foam DA Cutting Disc to the MT300 DA Polisher. Dispense a small amount of the compound directly onto the pad.

• Set the MT300 DA Polisher speed between 4,800-5.800 OPM’s. Work in a 2’ x 2’ section applying 2 to 3 overlapping passes with moderate pressure, followed by light pressure for following 2 passes. Do not let product fully dry.

• Wipe off the residue with a fresh, clean Meguiar’s Supreme Shine Microfiber Towel. Flip your towel to a clean side for a final wipe.

• Reapply the compound if you didn’t remove the defects with the first application. Apply in sections like this over the vehicle.

Method 3: Applying by Rotary Buffer

• Work one section at a time. Set rotary buffer to approximately 1000-1500 RPM’s.

• Dispense a small amount of the compound directly onto the paint and begin working in a 2’ x 2’ area with overlapping passes. Continue working until a light film remains.

• Wipe off residue before the product dries with a fresh, clean Meguiar’s Supreme Shine Microfiber Towel. Flip your towel to a clean side for a final wipe.

• Reapply the compound if you didn’t remove the defects with the first application. Apply the in sections like this over the vehicle.