- Miniature end mills create the intricate cuts needed for precision industries
- Four flutes produce a better finish than fewer flutes
- Carbide can run at higher speeds than high-speed or cobalt steel, offering increased wear resistance and high cutting temperatures
- Uncoated (bright) tools have no additional surface treatment or coating to retain miniature end mill's tight tolerances
- Ball nose end (also called ball end) creates contoured surfaces
Niagara Cutter N59868 Carbide Ball Nose End Mill, Inch, Uncoated (Bright) Finish, Roughing and Finishing Cut, 30 Degree Helix, 4 Flutes, 1.5" Overall Length, 0.023" Cutting Diameter, 0.125" Shank Diameter
We don't know when or if this item will be back in stock.
Specifications for this item
|Brand Name||Niagara Cutter|
|Finish Types||Uncoated (Bright)|
|Number of Items||1|
|Compatible Material||All Materials|
|Cut Type||Roughing and Finishing|
|Cutting Angle||30 Degrees|
|Cutting Diameter||0.023 inches|
|Cutting Direction||Right Hand|
|Cutting Length||0.072 inches|
|End Cut Type||Center Cutting|
|Flute Length||0.072 inches|
|Manufacturer Series Number||MEB430|
|Number of Flutes||4|
|Outside Diameter||3/128 inches|
|Overall Length||1.5 inches|
|Shank Diameter||0.125 inches|
|Shank Width||1/8 inches|
|System of Measurement||Inch|
The Niagara Cutter MEB430 miniature uncoated carbide ball nose end mill has four flutes and a 30-degree helix to create the intricate cuts and fine finish needed for precision industries such as electronics and medical-device manufacturing. Four flutes produce a better finish than fewer flutes. The 30-degree helix balances lower angles’ strong cutting edge for difficult-to-machine materials with higher angles’ increased cutting action. This allows efficient cuts in the difficult-to-machine materials common in precision industries such as stainless steel and reinforced plastic. The ball end is suited for contouring applications where sharp edges are not required, and the center-cutting design allows the tool to plunge into the workpiece like a drill bit.
The carbide substrate is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and providing longer tool life. With no coating or surface treatment, it features just the base material to help the miniature mill retain its sharp edges and tight tolerances. The tool has a total indicated runout (TIR) of + or - 0.0002”. This measurement defines the positional accuracy of the end mill’s horizontal movement from the shank to the cutting edge. To increase rigidity and ensure low runout, the tool should be held by a precision holder. Cutting diameter tolerance is + or - 0.0005”. All sizes have an overall length of 1 1/2” and a shank diameter of 1/8”.
End mills are designed to remove material and create multi-dimensional shapes and profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. The number of flutes can range from two to eight. Two-flute designs offer the most efficient chip removal, but more flutes provide a smoother finish. The shank is the end of the tool held in place by a tool holder or machine. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts.
Niagara Cutter has been designing and manufacturing precision cutting tools for over 50 years. Specializing in end mills, cutting mills, and saws, the company manufactures all of its tools at its two facilities in the USA. This allows the company complete control over production, an essential benefit for customers in a variety of industries, especially aerospace and automotive.