|Number of USB 3.0 Ports||1|
SB Components Clear Case for Raspberry Pi 3 Model B Quad Core/Pi 2 Model B/Pi Model B+ Cases
|You Save:||$2.77 (32%)|
- Enter your model number to make sure this fits.
- This is a no-nonsense protective case designed specifically for the Raspberry Pi 3 Model B
- The case is a two-piece injection-molded ABS enclosure that snaps together around the Raspberry Pi 2 Model B
- It provides the best available protection/accessibility for the Raspberry Pi 3 Model B
- Wall Mountable. Access to All ports.
- Raspberry Pi 3 or Raspberry Pi 2 model B not included
This item is available because of the Add-on program
Frequently bought together
Customers who bought this item also bought
This is an elegant and innovative protective case designed specifically for the Raspberry Pi 2 Model B. Based on the best-selling SB Components' Model B case this two-piece injection-molded ABS enclosure incorporates snap-fit mounting points that hold the Pi securely in place. It provides tough protection for the Raspberry Pi Model B+ along with access to all the PI consumer ports as well as DSI, camera and GPIO connectors.
Top Customer Reviews
This was a straight forward install for me, and I really like how clear it is. I can see all the things I wanna see clearly ( see the photo below ). It was easy to figure everything out and how it all worked.
All the slots are correctly located, for those engineer/nerdy types, all the slots have no more than .015 of an inch clearance, but everything is perfectly located. I use a name brand computer to place inside it, one that I know is right. After I placed the unit inside, placed the halves together, it snapped together perfectly as intended.
I'd say you won't go wrong with this unit, it might cost a little more, but what is a few cents when you get good quality. This is by all means a premium product.
I will disclose that I am a very honest and unbiased reviewer. If you like my review, or found it helpful, please click the "helpful" button below.
Here is the way: you put the board into two clips on one side first, leaving the other side hanging out. Then you put the lid of the case on the board. Press and lid and try to snap the case into closed position. The case edges will put pressure on the board evenly and snap it into place. Done.
Most Recent Customer Reviews
Is a bit difficult to put the pi in, but it holds it into place well.