|Item Weight||11.2 ounces|
|Package Dimensions||5 x 3 x 0.9 inches|
|Item model number||1012|
|Manufacturer Part Number||1012|
Other Sellers on Amazon
+ Free Shipping
+ Free Shipping
TIME-SERT Metric Kit M10 x 1.25 Part # 1012
|Price:||$86.44 & FREE Shipping. Details|
Fulfillment by Amazon (FBA) is a service we offer sellers that lets them store their products in Amazon's fulfillment centers, and we directly pack, ship, and provide customer service for these products. Something we hope you'll especially enjoy: FBA items qualify for FREE Shipping and .
If you're a seller, Fulfillment by Amazon can help you increase your sales. We invite you to learn more about Fulfillment by Amazon .
Frequently bought together
Customers who bought this item also bought
TIME-SERT is a sophisticated thread repair system that is considered by many to be superior to any other method of repairing stripped or damaged threads. TIME-SERTis a solid bushing insert. This facilitates easy installation and allows for full torque to be applied to repaired threads, ensuring a strong, permanent repair. TIME-SERTis thin walled due to synchronized internal / external threads. Small outer diameter allows for installation in areas where clearance is critical. TIME-SERTis self-positioning. The flange on the top of the insert will insure that the insert cannot wind down into the newly repaired hole. TIME-SERTis self locking. On installation the bottom internal threads of the insert expand to lock the insert in place.
Customers who viewed this item also viewed
Top customer reviews
The drill bit was very sharp. All the tools in the kit have a tap end (square drive). I bought a set of tap sockets to allow me to use my ratchet on the tap and insert tool. I had to figure out how to get the drill bit into the hole since the swing arm recess is long. I used a 9mm 12-sided socket to drive the drill bit - carefully guiding to make sure it was straight. After that it was easy to use the shouldering tool and tap. Since I have the tap socket I had no issue reaching the hole using an ratchet extension.
The insert went in painlessly and the new bolt was liberally coated with neverseize. This is not a high torque installation - the bolt is just used to set the axle distance to lessen chain slack - the axle bolt holds the swing arm in place.
I did not have enough room to use a drill without removing the EJ22 engine from the vehicle, but this was not an issue. The rear end of the drill bit came with the same square fitting used for the tap and die. I used the tap wrench to run the drill bit. This was harder than a drill, however, completed the job fine and I was able to run the tap right after. At first I was worried I would get it slightly crooked, which did not happen. Everything is together, and torqued to spec at 30 foot lbs.
The quality of the drill bit is superior.
The Tap is of great quality.
The threaded insert was easy to install, and now has a solid feel to it.
This is a great kit, and would recommend that it gets used instead of killing off the car in a junk yard.
Only thing is the shank bit drilled a bit deeper than I expected.
If you buy this to repair threads make sure you measure the hole depth after running the bevel into it!
A common mistake would be to measure your stripped out hole then order a time sert the same size! Order a size 1/2 the depth so you dont wind up with it hanging out.