The media could not be loaded.
This grill has been nothing but problems since assembly to use, items not fitting properly when being put together, defects, poor quality control.
First 40min break in the grill was okay, first time trying to grill steaks the grill got so hot it warped and the heat spreaders fell apart on the inside and knocked the hot box out of place then the grill also caught on fire, the 30 minute shut down process where it burns even hotter to rid it of excess pellet made it worse....
Okay thats fine things happen second grill session we used it as a smoker once it was reassembled again, grilled started to smoke excessive it turned out one of the coils had already burned out and the grill was smoldering, okay no big deal replaced coil cleaned out the pellet shoot fired back up, smoked a brisket and various foods for 15 hours no issues GREAT problems solved wrong....
Third grill session grill almost caught fire again from grease this time from one smoke session, you'll be aggressively cleaning this grill after every use to prevent a grease fire.
Fourth use another smoke session fired up in the morning all was well 240f it was cranking out clean heat, placed all of my meat on the smoker 45 min later I get a temp low warning, the grill has gone cold and has been dumping pellets into the feed with no fire for 30 min filling the bottom half of the grill..... OKAY after cleaning the bottom of the grill out of grease and pellets ANOTHER COIL WAS BAD REPLACED, clean empty shoot I turn the grill on with a fresh coil 20 minutes later I'm smoking out the block the pellets were not igniting fully from the new coil, I proceed to shut off the grill to inspect and it erupts in flames due to the fan kicking on for shut down all of my meat at this point is soaked in smoke and now burning due to flames kicking up....
This grill has not only caused tons of headaches and problems but now has ruined hundreds in dollars in food and a weekend.... weber needs to work on this grill A LOT your customers should not product testers for your unfinished products.
