No disponible por el momento.
No sabemos si este producto volverá a estar disponible, ni cuándo.
Entrega en Chicago 60602 - Actualizar ubicación
Agregado a

Lo sentimos; hubo un problema.

Hubo un error al recuperar tus Listas de Deseos. Por favor inténtalo de nuevo.

Lo sentimos; hubo un problema.

Lista no disponible.

100 pies 98.4 ft RG8X coaxial UHF PL259 conectores moldeados y soldados cable de antena de radio CB aficionado (100 pies 98.4 ft)

4.1 4.1 de 5 estrellas 301 calificaciones

No disponible por el momento.
No sabemos si este producto volverá a estar disponible, ni cuándo.
Marca exgoofit
Tipo de conector Pl259
Tipo de cable Coaxial
Color 98.4 ft
Género del conector Macho a macho

Sobre este artículo

  • Impedancia de 50 ohmios Cable coaxial RG-8X de 100 pies
  • Chaqueta de PVC negro OD de 0.242 "doble blindado
  • Cable coaxial de baja pérdida de alambre de cobre sólido
  • Lámina de aluminio y escudos trenzados de cobre, conectores de latón niquelados totalmente moldeados
  • 1 AÑO de garantía, envíe un nuevo artículo si el artículo no funciona dentro de 1 año

¿Buscas información específica?

Opiniones de clientes

4.1 de 5 estrellas
301 calificaciones globales
Do not purchase for any reason. PL259s not properly connected.
1 de 5 estrellas
Do not purchase for any reason. PL259s not properly connected.
First negative review on Amazon and I order a lot of stuff. I am a radio technician and have never seen such poor quality in a cable. Ground shield is not connected at all - should be soldered. I ordered many of these - all identical. All junk. Ground shield just haphazardly stuffed into connector / wrapped around center insulation core - see photo. From RigExpert meter reading - Photos attached - you can see the change from direct open to direct short simply by moving the cable a bit. Multimeter tests yield the same result. This is absolute garbage. Best case scenario the ground shield is never connected yielding poor performance. Worst case - the connectors short out destroying your electronics. If you are not ready to cut the PL-259 ends off and solder your own on - DO NOT PURCHASE. These should not be considered completed cable assemblies and should only be purchased by qualified radio technicians who test and repair the PL-259s before use.
Gracias por tus comentarios
Lo sentimos, se produjo un error
Lo sentimos, no pudimos cargar la opinión

Opiniones destacadas de los Estados Unidos

Calificado en Estados Unidos el 11 de agosto de 2023
The RG58X, despite it's diameter compared to other manufacturers, meets specification and performance.
Calificado en Estados Unidos el 2 de diciembre de 2022
I am very satisfied with my RG8X purchase. It arrived on time and it seems to be good quality.
Calificado en Estados Unidos el 13 de diciembre de 2022
First negative review on Amazon and I order a lot of stuff. I am a radio technician and have never seen such poor quality in a cable. Ground shield is not connected at all - should be soldered. I ordered many of these - all identical. All junk. Ground shield just haphazardly stuffed into connector / wrapped around center insulation core - see photo. From RigExpert meter reading - Photos attached - you can see the change from direct open to direct short simply by moving the cable a bit. Multimeter tests yield the same result. This is absolute garbage. Best case scenario the ground shield is never connected yielding poor performance. Worst case - the connectors short out destroying your electronics. If you are not ready to cut the PL-259 ends off and solder your own on - DO NOT PURCHASE. These should not be considered completed cable assemblies and should only be purchased by qualified radio technicians who test and repair the PL-259s before use.
Imagen del cliente
1.0 de 5 estrellas Do not purchase for any reason. PL259s not properly connected.
Calificado en Estados Unidos el 13 de diciembre de 2022
First negative review on Amazon and I order a lot of stuff. I am a radio technician and have never seen such poor quality in a cable. Ground shield is not connected at all - should be soldered. I ordered many of these - all identical. All junk. Ground shield just haphazardly stuffed into connector / wrapped around center insulation core - see photo. From RigExpert meter reading - Photos attached - you can see the change from direct open to direct short simply by moving the cable a bit. Multimeter tests yield the same result. This is absolute garbage. Best case scenario the ground shield is never connected yielding poor performance. Worst case - the connectors short out destroying your electronics. If you are not ready to cut the PL-259 ends off and solder your own on - DO NOT PURCHASE. These should not be considered completed cable assemblies and should only be purchased by qualified radio technicians who test and repair the PL-259s before use.
Imágenes en esta reseña
Imagen del cliente Imagen del cliente Imagen del cliente
Imagen del clienteImagen del clienteImagen del cliente
Calificado en Estados Unidos el 4 de mayo de 2021
The only dislike was the flexibility of the cable, very stiff, non-like the RG-8X cables I have worked with in the past. I have not seen the specs, just wonder if center conductor is solid rather than stranded.
Calificado en Estados Unidos el 23 de noviembre de 2022
im on my second 100 foot of this coax this time around just like the first 100 foot i had to send back who ever soldered the ends needs to be fired pure junk dead short
Calificado en Estados Unidos el 22 de noviembre de 2020
Landscaper accidentally tore up my RG8X with a chainsaw and I needed a quick fix to get it out to the tower. This came right away and has decent connectors on it. (Not molded plugs) It worked for me.
Calificado en Estados Unidos el 10 de agosto de 2020
Havent had the chance to use yet as theres too much lightening action going on and still need grounding cable but the polle and antenna are ready to be stood up hoping for good vibes on the ole airwaves
Calificado en Estados Unidos el 30 de julio de 2021
I liked the coax, it came quickly and serves the purpose, but I took resistance measurements from end to end on each conductor before I installed it through my attic and on the roof and and found >2 ohms on each conductor. The PL-259 connectors were merely screwed onto the shield, there was no real quality connection there. Certainly not enough quality to withstand time and weather - or the amount of power I will pump through it!

I pulled them off and soldered on high quality PL-259s on the cable to correct the resistance and secure the signal (reduce loss). If you are handy and confident in soldering PL-259s on, then it's still a value, otherwise spend more to get a better cable if you're concerned with losses, SWR or running power.

Opiniones más destacadas de otros países

Traducir todas las opiniones al Español
Joss Luigi
5.0 de 5 estrellas Calidad
Calificado en México el 12 de enero de 2023
Buena calidad de cable.
Gerry Moore
3.0 de 5 estrellas Not as advertised.
Calificado en Canadá el 27 de mayo de 2021
This coax is advertised as having a stranded center conductor. It does not.
The center conductor is solid making the coax very stiff and not at all flexible.
A una persona le resultó útil
Reportar
Dorothy Biagioni
1.0 de 5 estrellas Inferior product
Calificado en Canadá el 7 de junio de 2022
Stiff cable