Customer Review

Reviewed in the United States on January 5, 2020
I was looking for something to make tabletop miniatures with that wouldn't break when dropped, especially if the minis have small weak parts, like swords. I was using Elegoo, Anycubic, and Sainsmart resins in the past, and while they are all good, they were all brittle. Trying out the green Siraya, and so far, so good. It prints quickly with lots of detail, and so long as I cure it quickly (just two minutes in a glass jar of water with a UV light) it retains its flex. Also, I found that if , after printing, I soak the finished mini in hot water for 5 minutes or so, the supports will come right off, leaving no dents or chunks behind thanks to the resin softening just enough to do so.
81 people found this helpful
Report abuse Permalink

Product Details

4.7 out of 5 stars
4.7 out of 5
958 global ratings