My favorite filament by far!
Prints very nice, I use a heated bed at 60 c and a extruder at 220 c with a 7 mm retraction at 35 mm/s and printing at a 40 mm/s.
By Matthew C on October 18, 2017
It has a slight wood smell while it prints not like a wood shop but not like super cheap would smell either. Nor does the smell last long once it's done printing. It's quite easy to sand after and smooth out. I just had some oil wood stain lying around and it does take a lot of coats to get it the right color, other reviews have recommendation for stains that will probably work better than oil based. Once it's stained people find it hard to believe it was 3d printed.
Also please note this filament absorbs moisture from the air rather quickly so it's best to store it away in a air tight bag and heater it up a bit to dry it out before using it else you'll hear steam and popping noises.