Easy to Modify! I purchased this case for my DJI Phantom 2 Vision. I was very hesitant to purchase this item because it wasn't made specifically for the #2. I did have to make two small modifications, but they were very easy and the case is definitely the better than anything else I would have come up with. It is the right case for the Vision The propellers are longer on the #2 and have to be removed when carrying in this case. But, that is as easy as unscrewing them (Extremely easy) and to be 100%, only one of the props HAS to be removed, the others will fit. I just prefer to remove all of them because it is so easy. I would probably remove them even if they fit, just so there wasn't pressure applied to the prop. The controller is larger on the #2 also because of the FPV Phone holder, and is too large to fit into the provided space while fully assembled. What I did was use a carving knife from the block in the kitchen. The serrated edge made it simple to carve the foam. I eliminated the right corner of the foam molding, cutting right through the center of the pre-cut circle on the right upper corner, by the remote housing. This allowed all of the room I needed for the controller to remain fully assembled all of the time, and it made room for the props to rest after removal. The props now sit under motor number four in the case. I also enlarged the space set aside for the phantom 1 spare props, to fit the #2 spares.
It took me less than a minute to modify this case. The structural integrity was not compromised one bit and I am completely happy with the outcome. Even if go pro releases a new case for the #2, I won't need to consider it because this works beautifully.
10 people found this helpful.
Was this review helpful to you?