"So far it's the best motorcycle headlight switch I've had"
(Colorado springs CO)
So far it's the best motorcycle headlight switch I've had. The aluminum housing is so much better than the other switches I've used. I wish they made some versions with a 3 position switch. The red LED is reliable and bright, but I've only had it for about 10 rides (rough single track trail riding) so we will see if it lasts. The action isn't as solid as I would prefer but it's enough to keep the switch in the position it's left in. I'll update in the future as to the reliability but so far so good!
"The best LED lamps out there for the price..."
I bought this pair of LED lamps for my VStrom 650, 2016, based of another review on Stromtrooper website. First off; PRICE was unbeatable. I searched for many models, types, ratings, etc. and these from Lylla were the best bang for the money. Second: BUILT: inside the package there were two lamps and two switches, along with all the wires. The materials seem to be sturdy, not unbreakable aluminium and seems to be well sealed in the LED section. INSTALLATION: was very easy if you know what are you doing. I used the heater grip connector to obtain 12V from battery and connected the switch to the handlebar. Then wired each lamp and installed the lamps below the directional lights.
So far, I have ridden the led lamps on downpours, tropical storms and extreme heat conditions down here in Panama City, Panama and the lamps are doing great. No issues so ... full review
I needed a waterproof switch to put on my quad when I put on a LED light on the handlebars After reading the reviews & comparing different products, I choose this switch. But thanks to another post you have to watch how you wire it up. Black -positive, blue - accessory & tan is negative. I ended up buying another 1 for a similar install on another quad. I hope it holds up to the conditions it will be put through.
"Good product and use an ohm meter to figure out which wire does what."
This combination switch worked excellent! Bought for my barstool racer that I put electric start on. The button for the engine kill has three wires you can wire it either way for push in to shut off or out to shut off and momentary button for the starter. So far has worked well and would purchase again! There was no wiring diagram for which colored wire does what and that was no problem just used an ohm meter to check continuity.
"The design of the switch does make it easy to telll by feel if on or off"
Not sure how it's waterproof as it's all open at the bottom and no kind of seal around the switch but it does turn the lights on and off. The design of the switch does make it easy to telll by feel if on or off.
This product gives out a bright light which compliments my headlights on my motorcycle. They work especially well on the unlit county roads where I am able to pick up deer to my right and left up to 50 feet away. The product does not come with installation instructions. It would be nice if they did. Not everyone has experiece to figure out the set up.